Waste heat recovery equipment is needed for exhaust gases
Thread Content
The factory needs to recover waste heat, but due to poor design at the initial stage, the residual pressure at the end points is insufficient, at only around 100 Pa. Is there any solution?
The Platecoil heat transfer plate heat exchanger is recommended, as it features low resistance and is easy to clean
The Platecoil heat transfer plate heat exchanger is recommended, as it features low resistance and is easy to clean
Is the resistance reduced to 100 Pa? How easy is it to clean?
Yes, it can go as low as 50Pa. An access door can be installed, allowing the plates to be cleaned directly with water; if a plate gets damaged, it can be removed and replaced with another one.
The conditions specified for this exhaust gas description are incomplete; the pressure is 100 Pa, but what is the exhaust gas temperature? What is the traffic volume? There are also many options for recycling the waste heat from exhaust gases, but it still depends on the conditions of those exhaust gases.