The porcelain ball has blossomed again
Thread Content
In 2018, it occurred in System 1; in 2022, it happened in some parts of System 2; and in 2024, it affected almost the entire first layer of System 1. The teachers analyzed what caused it. Pay attention to the comments; I will share my analysis results later
The blooming of porcelain balls may be caused by material quality issues or improper control of temperature and pressure during the processing. A detailed analysis requires more information on specific operations and environmental conditions. Looking forward to seeing your analysis results. .
Based on consultations from various sources, the reasons for the blooming of ceramic balls have been compiled for reference only. Personally, I have ranked these reasons according to their potential impact on blooming: 1. The ceramic ball is too large, resulting in insufficient strength and leading to temperature differences between the inside and outside of the ball. 2. The system shuts down and starts up frequently. 3. Quality issues with ceramic balls. 4. The moisture content in the acid mist is too high. 5. The flue gas contains too much fluorine.
What is this device of yours? It seems that the alumina content in the ceramic ball is too low.
Sulfuric acid is produced from smelting flue gas; it’s probably because the ceramic balls are too large