E+H radar level gauge
Thread Content
This post was last edited by yuchenchf on 2017-3-19 09:54. With the E+H radar level gauge, the level fluctuates by about 10% during material inflow and outflow; this may be due to the following reasons: 1. Improper installation (the flange of the level gauge is not connected directly to the top of the tank but via a reducing flange, resulting in an overly long blind zone and preventing proper transmission of the wave signal); 2. Interference signals present inside the tank, which can be mitigated by appropriate measures
I learned it! Thank you to the original poster for sharing. . .