What precautions should be taken when replacing the hard drive in the CS3000 engineer station host?
Thread Content
The recording curves of our company’s DCS CS3000 system have been dropping frequently lately, with no alarms or alerts from the system. We suspect there is a problem with the hard drive in the engineer station. What precautions should be taken when replacing the hard drive in the engineer station? Thank you!
It depends on which system is being used; usually, a backup should be created before making any changes, and the installation procedures for that system should be followed, with relevant IP addresses and settings recorded.
Can’t you just back up directly from the old hard drive to the new one?
Remember, before backing up, be sure to perform the save tuning parameter operation; this step is very important
Replacing the hard drive is the same as installing the CS3000 software anew; just follow these instructions. Also, make a backup of the latest project. It seems that the trend data is also disconnected; this should be related to the historical trend station