Valve positioners without HART protocol
Thread Content
The valve positioner does not support the HART protocol; are there any other protocols available? Does the fact that it lacks any protocol and only provides a 4-20mA signal have any impact? What is the difference between it and one that supports HART?
Those without the HAET protocol can be used normally; HART is just an additional signal. This connection allows the use of a handheld device to view process parameters, diagnostic information, etc., as well as to modify the configuration manually. Yokogawa also has a BRAIN TM
Positioners without the HART protocol typically have buttons on them, which can be used to adjust and diagnose the positioner
Positioner type: Traditional pneumatic analog positioners, intelligent digital (HART or FF bus, as well as PF protocol, etc.) positioners.
The 4-20MA signal remains completely unaffected without any protocol; HART exists solely to facilitate communication, debugging, and diagnosis.
HART is only meaningful when communication is established manually
Valve positioners without the HART protocol can only be configured or have their circuits adjusted through a DCS, which makes on-site maintenance less convenient.