Installation of pressure transmitters
Thread Content
I would like to ask everyone**, whether this installation method is feasible for remote pressure transmitters; note that the liquid flows in a downward direction
It is unreasonable; it should be installed on horizontal pipes. If installation is to be done on a vertical pipe, the flow direction should be from bottom to top. When the fluid flows from top to bottom, if there is a condition of insufficient fill in the pipe, pressure errors occur due to gravity.
Thank you. If it is installed in this way, should the display value of the pressure transmitter be higher or lower?
There is nothing wrong with your installation method, but it’s best to install it at the highest point of the pipeline to prevent material buildup from affecting measurement accuracy