Help identify what device number 3 is in the picture
Thread Content
The gas phase exits the pressure reducing valve and enters Unit 3, but I don’t know what it’s called. Number 2 is the coil; number 1 should be the electromagnetic directional control valve. I would appreciate some guidance from those who are more experienced
Solenoid valve exhaust port (muffler installation port)
3 appears to be the air inlet; it comes out of the dryer, passes through the pressure reducing valve, and then enters the solenoid valve
Is it the dry adsorption part? There are holes inside for air intake
It is a heat-regeneration dryer for instrument air
It should be the solenoid valve exhaust port (the port where the silencer is installed)
It should be the solenoid valve exhaust port (the port where the silencer is installed)
This post was last edited by hlgcqx on 2017-12-4 08:03. The regenerative drying unit – this is likely the base for the solenoid valve, or it can be referred to as a connection plate. When purchasing, pay attention to the model of the solenoid valve; it’s possible to get an entire set including quick connectors, mufflers, and plugs, which will help avoid any mistakes
The solenoid valve base is generally used when multiple solenoid valves share one air supply; the fact that there is a single solenoid valve here is likely intended to facilitate installation.