Is it necessary to use a material discharge method to change the orientation of the dial on a vortex flowmeter?
Thread Content
I would like to ask everyone: does changing the orientation of the dial on a vortex flow meter suffice to empty the material inside the pipe?
Changing the table header has nothing to do with the material inside the pipeline.
I didn’t understand what the landlord meant.
It means the header drops down, I guess. There is no need to queue materials.
Some instrument dials have a very small set screw underneath them, usually of the hex head type; by loosening it, the dial can be rotated 90 degrees left or right, and then it can be tightened again. Most instrument manufacturers take this into account; of course, there are also manufacturers that only use a simple, basic design.
I have used Chuanyi vortex flow meters to adjust the direction; there is no need to discharge material, but attention should be paid to the sensor wires
Hmm, I can see the hex key; it seems there’s no need for layout planning. Thank you.