Analysis of reasons for no flow display in turbine flowmeters
Thread Content
This post was last edited by tiandiyi*an on 2018-4-10 at 11:12. Analysis of reasons why flow rate is not displayed on vortex flow meters: 1. Check for any breaks or poor connections in the power cable, fuse, function selection switch, and signal lines. 2. Inspect the internal printed circuits and contacts of the display unit for any problems related to poor connections. 3. Examine the sensing coil. 4. Check for internal faults in the sensor. If items 1–3 show no issues or the faults have been resolved yet the problem persists, it indicates that the fault lies within the sensor’s flow channel. In such cases, check whether the impeller is touching the inner wall of the sensor, whether there are any foreign objects stuck there, and whether there are any obstructions or breaks in the shaft and bearings. Gas flow meters, orifice plate flow meters, V-cone flow meters, ultrasonic flow meters, etc
Sometimes it’s the vortex street, sometimes it’s the impeller bearing. . . OP, your breasts are so big, so huge. The monkey wants to cause trouble. {:2_42:}