Problems with the protective sleeve of radio frequency admittance level gauges
Thread Content
Dear colleagues, there is a bottom-mounted radio frequency admittance level gauge in the distillation column bottom; it is 1300 mm long. Is a protective sleeve needed? Should it be done on the device or brought along? Can anyone help answer this?
1300mm is a bit long; it needs to be protected. It’s best to have the pot manufacturer make the necessary preparations so that it can be installed right away upon arrival
Hello, does the level gauge come with a sleeve? Should a sleeve be installed inside the tower bottom?
A sleeve is installed inside the tower, but you need to consult the manufacturer of the level gauge – the sleeve must not affect its ability to take measurements