E ➕H Hollow Street flow meter – for measuring steam at full scale
Thread Content
The range, medium, and unit have all been changed; the unit is now one of density. One stream of steam corresponds to the full range – what should I do?
Is the pipeline vibration severe? Is the range selected for the flow meter too small?
Check with the manufacturer to see if there is a problem with the settings; many domestic vortex flow meters have DIP switches, and it’s important to ensure that they are in the correct position.
What does it mean that everything has been changed? So it’s not for measuring steam? It can’t be changed just like that.
The description is unclear; please send the instrument parameters as well as those of the medium being measured. There should also be a data sheet available
The density value and unit must be set correctly.
It is a new gauge; it reaches full scale after being pressurized with steam. The range was adjusted according to the range displayed on the DCS, and the units were changed accordingly; the pipeline is not vibrating
It is a new gauge; it reaches full scale after being pressurized with steam. The range was adjusted according to the range displayed on the DCS, and the units were changed accordingly; the pipeline is not vibrating
It is a new gauge; it reaches full scale after being pressurized with steam. The range was adjusted according to the range displayed on the DCS, and the units were changed accordingly; the pipeline is not vibrating
It is a new gauge; it reaches full scale after being pressurized with steam. The range was adjusted according to the range displayed on the DCS, and the units were changed accordingly; the pipeline is not vibrating
The answer doesn’t address the question. Instruments cannot give accurate readings just by setting some parameters arbitrarily; if that were the case, then what would be the purpose of instrument technicians? Their roles include design, manufacturing, installation, and calibration – without proper coordination in any of these stages, accurate measurements are not possible. It’s recommended to start by examining everything from the beginning