Problems with the Yokogawa VP MC-2 module and SIO-2 module
Thread Content
I used this module in the CS3000, but when it comes to VP, there’s no need for any connections for output. The MC-2 should have 3 inputs and 3 outputs, while the SIO-2 should have 2 inputs and 2 outputs. I checked the channels as well; all the channels are configured, but where is the configuration for the outputs?
From your screenshot, MC-2 has only one input; the SIO-22 input is connected directly, and the output should be inside LC64 :)
You can also directly search for the relevant names; you should be able to find what you’re looking for
I remember that previously, entering a value would allow connection to one channel, and the channels beneath that connected channel would then be used automatically
The outputs of these two blocks are not connected to anything; I thought some feature had been enabled that allowed the outputs to function without being connected. So that’s not how it is, then? ? ? ? ?
The two connected channels must be adjacent channels; otherwise, both points must be connected to the module
Definitely not; it’s not necessary to use them all connected. That MC-2 is probably just for display purposes