When there is a coil heater inside the storage tank, where is the appropriate location to install the radar?
Thread Content
There are currently some storage tanks that have coil heating inside them as well as mixing mechanisms; the distance from the coil heating elements to the mixing blades is approximately 400 millimeters in those tanks. The installation instructions for the high-frequency radar state that it should be installed at a distance of more than 200 millimeters from the wall surface； But now there is internal coil heating, so I plan to install it 200 mm away from the coil heating. However, since the coil heating is different from a smooth wall surface, I’m a bit worried, which is why I’m seeking advice.
Radar level gauges are used in the storage tanks; there are heating coils on the outside, and agitators are also present at the top. Given the limited installation space, why not consider using differential pressure level gauges?
This post was last edited by GeniusTTUV on 2022-7-4 18:05:2211111
Open the waveguide at a location that avoids the impeller blades