If you’re having trouble measuring the pressure level, come ask me, Brother Pig. I’ll ensure that you’re not misled or misinterpreted, and that you don’t have to take detours
Thread Content
This post was last edited by 1111111 on 2018-9-29 07:40. If you’re having trouble measuring the pressure level, come ask Brother Pig – I’ll ensure you’re not misled or misinterpreted, and that you don’t have to take detours.
Could you explain what happens to the diaphragm in a diaphragm pressure gauge? I’ve always been curious whether it’s welded onto the gauge or whether it’s included as part of the gauge from the start.
The corrugated diaphragm is made by stamping out very thin sheets, as thin as paper, and then welding them to the base.
For differential pressure flange level gauges, how is the first installation and relocation carried out? If it’s not allowed during production, then how can it be handled without removing the flange? Also, why can’t the differential pressure level gauge with a pressure guiding tube be reset using 475? What’s the reason for this? The only way to display 0 is by changing the range.
Answering one by one: 1. \"For differential pressure flange level gauges, how is installation and relocation carried out for the first time?\" " Answer: Once the flanged differential pressure gauge level gauge is properly installed, the reading shown by the differential pressure gauge when the tank is empty represents the migration amount.
Answer one by one: 3. “Why can’t the differential pressure level gauge with a pressure guiding tube be reset using 475?” The only way to achieve a display of 0” is by changing the range. Answer: 475 is not allowed; it’s not necessary to use it, so that’s the end of it. On-site, by using the migration volume parameter to handle all zero-setting issues, you’re good to go. . . The software for the handheld controller wasn’t written by me; I’m just too lazy to make random guesses. After all, Luo is an expert in voltage regulators – he’s a genius. It would be wrong to guess what’s going on in that foreigner’s mind; doing so could result in losses and embarrassment, and it would harm the harmony during our country’s National Day celebrations. :lol
During the first installation of the gauge, after verifying it, the upper and lower flanges are temporarily attached to the pressure tapping points using bolts without tightening them; thereafter, the zero setting is performed using a hand controller, and finally the bolts are tightened to complete the commissioning process. Can it be done this way? Is it the same as adjusting the range offset? Is there a difference?
Zeroing means setting the migration amount parameter to 0
Can’t it be reset using a handheld device? How, if possible?