Triconex channel
Thread Content
I’ve just started learning this system and am not quite sure how, after the card is installed, its variables communicate with the actual card. This is because it doesn’t allow for the addition of channels like those in systems from Control or Honeywell; memory is allocated automatically in this case
This post was last edited by chensf123 on 2018-10-16 at 17:52. There is something called a tagging dictionary, and all points are defined through this tagging dictionary. It follows the same principle as the I/O cards of all PLCs.
The address can be changed; the upper-level system relies on address correspondence, through OPC or DDE communication
I took a closer look today and understood that there is indeed a list for adding card address channels. Thank you all. Does anyone have any configuration materials that I could use to study it?