Polling configuration
Thread Content
How to configure the Gaon 1700 to display an A115 alarm (with no external information input or polling data) using a handheld programmer?
The manual contains troubleshooting information, and the pictures are part of it
What kind of table is this? I’ve never seen one before, bro. For polling, there seems to be a setting in 475; it basically means that by default, there is only one device per loop. If a loop has multiple devices, the polling options need to be modified by changing the settings in the HART application. But I’m not sure if it’s this problem. I don’t know what kind of watch it is because I’ve never used yours. I have an Emerson differential pressure flow meter here that also can’t communicate, and the truth is that the device hasn’t been found. I haven’t tried it yet; I’m not sure if it’s due to the 250-ohm resistor or an issue with the device polling
It’s a section from the troubleshooting chapter of the user manual for the Gaozhun 1700, as posted by the original poster
This watch is the Emerson 1700
For use with CMF400 Emerson flowmeters
If the handheld controller cannot communicate, it can be connected using a computer via ProLink
Between 1700 and the control system, does this 1700 represent the communication method used to send signals to the control system?