How to set the range for the E+H FMR54 radar level gauge
Thread Content
This post was last edited by liu530014416 on 2020-10-10 20:38. For on-site instruments, I see parameters for the empty mark and the full mark. If the liquid level range is 10m, how should the parameters for the empty mark and the full mark be set? Empty mark = 10.25 (25 cm is the distance from the header to the highest liquid level); full mark = 10. Is this the correct setting? If the top and bottom of this container are oval in shape, and the liquid level within those oval areas is not taken into account, how should the empty and full marks be set?
Looking at it, the total length of your container is 4 meters. I think the zero point should be a few centimeters below the radar horn’s opening; if the horn’s opening is 30 centimeters, then you should set it around 3.7. Setting the full mark to 3.3 is sufficient