Add module to Hilscher MACs v5.23
Thread Content
As shown in the diagram, this is the actual layout and it corresponds to the position of the dial module. I want to add another module; the device configuration now shows it as 47#. In the \"Graphs – Import Files\" option, there is no corresponding graphic template available, as all the template graphs are square in shape, while the actual graphs have varying lengths. Is it possible to use functions like copy and paste on the actual graph? For example, copy a module of the same type, paste it below 46#, then change its number to 47 and save it? So, when the system status diagram is opened while online and module 47# is clicked, the corresponding online values will be displayed, right? I’m asking everyone for advice
Upon importing the file, a new layout diagram should be generated, and 47# will appear in it; you can adjust the position according to the actual layout. Copying and pasting seems not to be very useful in this case. . .
If nothing is generated after the file is added, please check whether the module was installed after it was added earlier; if it wasn’t installed properly, nothing will be generated either. Additionally, it seems that initializing the installation is required when adding a module, and this can only be done when the vehicle is stopped. I haven’t done it in too long, so I can’t remember very well. . .
It can generate the corresponding module, but the layout is different; you can give it a try under certain conditions. Thank you