What is the operating cycle of centrifugal pumps used for slurry transport?
Thread Content
Our company has always used screw pumps for slurry transportation; the rotors wear out severely and the service life is short. Has anyone used centrifugal pumps for this purpose? How’s the cycle?
The feed flow of screw pumps is stable with no fluctuations, while centrifugal pumps experience fluctuations, though these are acceptable; centrifugal pumps certainly have a longer service life
Centrifugal pumps can be used for low-pressure coal slurry pumps, and wear is relatively severe; the impellers and volutes usually last for 3 to 4 months
We should be the first to use centrifugal pumps, and they are performing very well. The common wear part at present is the mechanical seal, which generally needs to be replaced every six months on average
Thank you! May I ask which pump manufacturer produced it?
Thank you! Which are some of the better centrifugal pump manufacturers in China for transporting slurry?
Shanghai Foster; Shen Ye seems to be a good option as well
Centrifugal pumps are easier to operate than screw pumps
Hello, where is your company located? Is it the centrifugal pump from that manufacturer? Could I learn about it?
You can go to Inner Mongolia Xinneng Energy for a visit; they are the first in China to use centrifugal pumps for low-pressure coal slurry
Centrifugal pumps are suitable for low-pressure coal slurry pumps, and they perform well; however, the viscosity of the coal slurry cannot be too high.