What is the difference between connecting gas and merging gases in the gas shift operation? What should be noted when taking breath?
Thread Content
What is the difference between connecting gas and merging gases in the gas shift operation? What should be noted when taking breath?
Different processes are different; you need to give a general idea of what kind of process you have
The gas supply consists of the water gas supplied by one gasification furnace, while the gas is the water gas supplied by two gasification furnaces
For gas equalization, it is sufficient to mainly adjust the temperature of the converter bed layer and the level of the waste liquor; for gas guiding, attention must be paid to warming the pipes in the system, the temperature change trend of the converter during gas guidance, and pressure increase
If you mean partial conversion of raw gas, during gas introduction the large bypass is used first, with the gas going straight to the flare； Then, the entire system is pressurized through flare venting, and the gas is fed into the converter ； If it is a full conversion with direct gas connection, controlling the voltage rise rate properly will suffice