Quality of hydrogenated gasoline
Thread Content
Why is the initial boiling point of gasoline controlled during hydrogenation rather than the dry point? What is the purpose of controlling the initial boiling point? I would like to ask the experts here
For gasoline fractions, the dry point changes little after hydrogenation, but the initial boiling point changes significantly. Because during the hydrogenation process, a small amount of small-molecule hydrocarbons are produced, and these hydrocarbons affect the initial boiling point of gasoline.
What effects does a low amount of gasoline in mixed hydrogenation have on the bed temperature, hydrogen partial pressure, and hydrogen consumption of the reaction?
Don’t you have any process operation guidelines? The bed temperature is related to factors such as the feed temperature of the raw material, the olefin content in the crude oil, and catalyst activity ； The hydrogen partial pressure is related to the circulation rate, the amount of fresh hydrogen added, and some related operating conditions ； Hydrogen consumption, on the other hand, is related to the degree of hydrogenation and the properties of the feedstock. Do you think these parameters are all isolated?
What are your downstream devices? Could it be related to the properties of the raw materials required by those downstream devices?
I’m learning hydrogenation on my own; I don’t know the specific parameters, sorry for that
We shipped it out right after the hydrogenation process
The initial boiling point affects the flammability of gasoline; too low a value may impact its storage safety. Also, a too low initial boiling point would likely affect its performance in the engine; it would probably cause knocking
We do not control the dry point; the initial boiling point generally shows little variation and is therefore not controlled. The dry point is controlled in order to regulate the feed for reforming
The dry point of gasoline is actually under control; perhaps hydrogenation of gasoline isn’t controlled, but the raw materials used in upstream catalytic stabilization do control the dry point of the stabilized gasoline； As for the initial boiling point, it is intended to raise the flash point and control the saturated vapor pressure