Nitrogen in the circulating hydrogen compressor tank
Thread Content
Is nitrogen being injected into the compressor oil tank of your unit? When will it be put into use? ?
The nitrogen on the circulating hydrogen compressor oil tank is used to protect the equipment, prevent oil oxidation, and reduce the risk of explosion. Nitrogen is typically used inside the fuel tank to isolate air and moisture. The exact time of commissioning is determined based on the equipment’s operating conditions and safety procedures; it usually takes place before startup or after a maintenance restart. For more detailed operating instructions, please refer to the user manual of the specific device or consult the device manufacturer. .
Yes, it’s needed. As soon as hydrogen is supplied to the equipment, it’s required.
It has not been put into use; nitrogen is used in the design to prevent oxidation upon contact with air, although there is no possibility of such contact during normal operation.
The nitrogen in the compressor oil tank is used to protect the equipment, prevent the oil from oxidizing, and reduce the risk of explosion.
It can be done before or after filling the tank with fuel; just don’t use too much nitrogen, as this will slow down the fueling process.
It’s fine whether to use it or not; I think it’s normal and there’s no need to use it. If it is used, ensuring a slight positive pressure is sufficient. Put simply, it’s about isolating from air.