Packed Tower Hydraulics Calculation
2020-05-06View Original
Thread Content
Dear friends, is the pan point rate calculated by this hydraulic calculation too low?Reply #22020-05-13
The requirement of 60-300% is unreasonable in itself
Related Threads in This Forum
← Previous
- Regarding the methanol water distillation tower - HCBBS Foru
- What are the requirements for the design of the safety inlet
- When should a primary distillation tower be installed in a a
- Tower internals requirements - HCBBS Forum
- Request the equipment condition diagram for the spray drying
- Installation plan for tower internals - HCBBS Forum
- The problem of easy evacuation in heat transfer oil gas sepa
- How to remove the hook from the lifting lugs after the tower
- What documents are required for the registration of an atmos
- Reasons for excessive hydrogen sulfide levels in the dry gas
Next →
- Everyone, could you help me figure out what the two diagonal
- Hydrogen chloride exhaust gas absorption tower (packed tower
- Catalytic reaction to cut off the feed fractionator bottom l
- Regarding the problem of the bubble pump after Air Liquide r
- I have encountered some problems in the simulation of the fo
- Distillation design, distillation equipment – mutual success
- I am performing design calculations for the absorption tower
- Propane removal column in the gas phase - HCBBS Forum
- Calculation sheet for absorption tower - HCBBS Forum
- The lubricating oil is refined using furfural; why isn’t the
Translated at 2026-07-26 10:54:23
Original: https://bbs.hcbbs.com/thread-2985034-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.