Everyone, take a look – is this corrosion?
2017-11-30View Original
Thread Content
Are these patterns a result of corrosion?Related Threads in This Forum
← Previous
- 【Ten Years of Rapid Development in Chemical Engineering Equi
- Knowledge of fluid mechanics - HCBBS Forum
- Flow performance curve of diaphragm pumps - HCBBS Forum
- How to determine the flow direction of the medium in a wafer
- Hydraulic oil pump pressure returns to zero - HCBBS Forum
- Confirmation of parameters related to jet pumps - HCBBS Foru
- Water ring vacuum pumps can experience either over-pumping o
- I want to purchase dry vacuum pumps; what are some good bran
- Precautions for using chemical process centrifugal pumps - H
- What to do if a screw vacuum pump used for vacuuming is not
Next →
- Selection of materials for mechanical seal bellows - HCBBS F
- Calculation of pump inlet diameter - HCBBS Forum
- Small air-cooled screw vacuum pump - HCBBS Forum
- What is the typical range within which the axial play of the
- Problems with constant head pumps (tangential pumps) - HCBBS
- What is the static pressure start of a pump? - HCBBS Forum
- Impeller connection type of FSB pump - HCBBS Forum
- 【Daily Question】Pump Equipment Technical Exchange Edition 20
- What are the differences between version 10 and version 11 o
- How should a Nippon Sharyo plunger pump that is severely wor
Translated at 2026-07-21 03:32:36
Original: https://bbs.hcbbs.com/thread-1874474-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.