Circulation water pump vent pipe
2021-05-02View Original
Thread Content
I’d like to ask the experts: why is the vent pipe at the top of the circulation pump connected to the shaft seals on both ends?Related Threads in This Forum
← Previous
- TkL slurry pump shaft P206, German-made 1011-3 - HCBBS Forum
- IS centrifugal fire pump repair and pump assembly disassembl
- Six maintenance instructions for magnetic pump - HCBBS Forum
- Information on IMO three-screw pumps - HCBBS Forum
- Pump seal flushing medium - HCBBS Forum
- I would like to ask about the methods for transporting bromi
- Why are auxiliary devices needed for mechanical seals? - HCB
- 【Daily Question: Pump Equipment】Fill-in-the-blank question,
- I would like to ask what kind of pump would be better to cho
- 【Daily Question: Pump Equipment】Multiple-choice Question 201
Next →
- What are the consequences of operating a centrifugal pump fo
- Can asbestos board be used as the gasket for the large cover
- Structural diagram of Fengqiu WQ series non-clogging submers
- Mechanical seal manufacturers - HCBBS Forum
- Can the medium in a diaphragm metering pump flow back? - HCB
- 【Daily Question】Pump Equipment Technical Exchange Edition 20
- Please calculate the gap of this mouth ring - HCBBS Forum
- The issue of competing for flow rate between two pumps - HCB
- Large self-priming pump pipeline inspection is insufficient
- Why can’t I follow the post anymore? - HCBBS Forum
Translated at 2026-07-26 09:12:28
Original: https://bbs.hcbbs.com/thread-3209203-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.