Solenoid valve tripped
Thread Content
I used a solenoid valve with a fluorocarbon lining; it’s the type that shuts off when power is cut off. However, it trips as soon as power is applied. What could be the reason for this? Thank you all
Is the wire connected incorrectly? Or is the load on the power switch too high?
Excessive load, or the solenoid valve is grounded
Please check the voltage rating of the solenoid valve
1. Please check the voltage rating of the solenoid valve you are using to see if your supply voltage matches it. 2. Check whether the insulation of the coil is in good condition. 3. Determine whether there is a problem with the power supply circuit itself; try using a different power supply circuit
Check the supply voltage to the solenoid valve, and then test whether the solenoid coil is short-circuited.
Things like current overload are the most likely, for example, a short circuit in the electromagnetic coil, or the coil relative to ground
1. The load on the solenoid valve itself is greater than that of the circuit breaker (the selected circuit breaker is too small). 2. There is a short circuit in the wiring of the solenoid valve. 3. The wiring of the solenoid valve is grounded. 4. The coil of the solenoid valve is short-circuited or grounded