HCBBS Forum (English)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

Squealing sound from the centrifugal pump’s seal

2015-06-14View Original

Thread Content

We have a centrifugal pump that uses two-stage mechanical seals in series. A few days ago, the seal in the first stage started leaking, so it was replaced. After the replacement, the seal continued to make a whistling sound, quite loud and continuous. However, the temperature of the seal wasn’t high, around 50 degrees. The mechanic couldn’t identify the cause and kept suggesting that we wet the belt. Could anyone help analyze whether this is an installation issue or a problem related to operation?
Reply #22015-06-14
Are you sure the sound is coming from inside the mechanical seal? I have dealt with the issue before, where the bearing dust covers and the bearing caps were too close to each other, causing friction and noise
Reply #32015-06-14
It’s likely that the noise is caused by air leakage due to improper installation of the mechanical seal.
Reply #42015-06-14
What does it mean to keep watering the belt? It is best to clarify the operating conditions, the specific type of mechanical seal, the flushing method, etc., so that everyone can carry out an analysis. Is the tone audio very stable, or does its volume fluctuate?
Reply #52015-06-15
The issue lies with the mechanical seal; this has happened with other pumps as well in the past – sometimes, by spraying some water on the surface of the mechanical seal, the noise is reduced or disappears
Reply #62015-06-15
It’s possible that the setting screw of the mechanical seal on the shaft isn’t tightened properly, causing it to rotate along with the shaft.
Reply #72015-06-15
Is it the sound coming from the mechanical seal? If the friction pair is made of such a material, its service life will definitely not be good
Reply #82015-06-15
It’s probably the bearing near the mechanical seal; if the mechanical seal makes a whistling sound, that’s terrible
Reply #92015-06-15
But indeed, the sound does decrease after spraying water on the mechanical seal; there was noise before as well, but it was intermittent
Reply #102015-06-15
I don’t know; I work in the manufacturing field and don’t understand these things, so I’m asking everyone
Reply #112015-06-15
That mechanical seal no longer leaks; the medium is no longer escaping

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.