Use of conversion catalysts
Thread Content
In actual operation, how can operations be carried out to extend the service life of the conversion catalyst?
This shouldn’t be asked in the moving equipment section~! Just check the catalyst instructions.
Keep the furnace temperature stable; whenever possible, reduce the steam-to-gas ratio, as excessive steam will lead to an increase in the resistance associated with catalyst pulverization
Another point is that the gas purification efficiency needs to be improved
Stable operation, with no significant fluctuations in temperature； Excellent gas composition
Control the temperature carefully to avoid overheating, and drain the condensate from the pipes during operation to prevent it from reaching the catalyst.
During use, pay attention to the following points: 1. Ensure that the CO content at the outlet does not exceed the specified limit; try to keep the inlet temperature as low as possible, and avoid raising it arbitrarily； 2. When parking, use nitrogen to purge it once if possible ； 3. When using the vehicle for gas guiding, prevent overheating (by adding nitrogen, steam, etc.) ； 4. Avoid bringing water and dust ；
Thank you! It’s pretty comprehensive overall.
During use, pay attention to the following points: 1. Ensure that the CO content at the outlet does not exceed the specified limit; try to keep the inlet temperature as low as possible, and avoid raising it arbitrarily； 2. When parking, use nitrogen to purge it once if possible ； 3. When using the vehicle for gas guiding, prevent overheating (by adding nitrogen, steam, etc.) ； 4. Avoid bringing water and dust ；