Can adjusting the water addition amount in a water ring vacuum pump adjust the vacuum level?
Thread Content
Adjusting the amount of working fluid added can regulate the inlet vacuum level; what is the principle behind this?
With less water, there are fewer areas where a vacuum is created, so the degree of vacuum is low; conversely, the opposite is true
The amount of water that enters the vacuum pump is equal to the amount of water that is expelled; it’s a one-to-one relationship. Therefore, as long as the power output of the motor allows it and within certain limits, increasing the amount of water fed in can improve the vacuum level, as more heat is removed in doing so! But note that \"within a certain range\" is related to the pump size
Increasing the water flow rate by itself does not raise the pump’s vacuum level, but it does work in practice because an increase in water flow leads to a decrease in the water temperature inside the pump. As the water temperature drops, the saturated vapor pressure decreases, and as a result the pump’s vacuum level increases. Ultimately, adjusting the water inflow is equivalent to adjusting the water temperature.
The air volume between the two blades is adjusted by the amount of water flow. The water volume must be sufficient to form a complete liquid ring, and at most it should be less than the volume between two blades.