Which is better, Spayark valves or Armstrong’s?
Thread Content
This post was last edited by Sammy_Wang on 2015-8-10 08:29. Which is better, Spillark or Armstrong’s pressure relief valves? What brand does everyone use?
We usually use Armstrong’s; Spazhack’s is good too, but I haven’t used it.
Personally, I think Spysack with the floating ball is good, while Armstrong is strong in inverted barrels and thermodynamic types
Both Armstrong and Spillark produce a wide variety of valves; which type of valve is the poster referring to?
Armstrong is used more often, but it works fine as well
I’ve used Armstrong’s inverted barrel steam traps; they are of good quality and quite reliable.
It’s relatively objective, but Armstrong’s thermodynamics isn’t the best.
Shaq’s advantage lies in floaters, while Armstrong’s advantage is inverted buckets; their strengths as players are different. Domestically recommended: Yingqiao
Is it called a drain trap or a steam trap? To be precise, it’s a strainer, right?
For check valves, this is something that needs to be considered; both of these brands are good. A specific analysis is required depending on the operating conditions. Their advantages are quite obvious and straightforward
In the light industry, Armstrong is slightly weaker in terms of brand. In harsh operating conditions, Spyshark’s quality is average. Being practical, TLV, Mark Danieli, 317, Watt, and Gongxie are all acceptable. Domestic Red Peak 920 and Chenghang are quite good.