How to adjust the detection probe for detecting the descent of the piston rod in a reciprocating compressor?
Thread Content
How to adjust the detection probe for detecting the descent of the piston rod in a reciprocating compressor?
The installation of the piston rod settlement monitoring sensor is basically the same as that of our eddy current sensors used for vibration measurement, as it is also adjusted based on the gap voltage. However, one difference is that the surface of the piston rod is coated with chromium or some other metal to provide wear resistance; this can result in unstable electrical fluctuations on the surface of the piston rod. Therefore, initial testing is required after installation, and compensation must be applied during configuration.
After checking the installation distance between the probe and the piston rod using a feeler gauge, set the zero point of the instrument
Which manufacturer makes the eddy current sensor? Do you have their contact information?