Regarding the arrangement of waste boilers in rows and columns
Thread Content
What are the respective functions of the in-line and between-row arrangements in the waste heat exchangers on the synthesis loop?
Continuous discharge constitutes a type of surface discharge; it involves releasing boiler water with a high salt concentration from the surface, thereby keeping the salt content of the boiler water within acceptable limits. This helps to reduce boiler water expansion and foaming, as well as the humidity and salt content of the steam, and it also helps to minimize scaling inside the evaporation tubes； Intermittent discharge, or regular sewage discharge, is primarily used to remove the sediments that form in water as a result of the addition of chemicals that increase water hardness.
It refers to continuous discharge and periodic discharge
Continuous discharge constitutes a type of surface discharge; it involves releasing boiler water with a high salt concentration from the surface, thereby keeping the salt content of the boiler water within acceptable limits. This helps to reduce boiler water expansion and foaming, as well as the humidity and salt content of the steam, and it also helps to minimize scaling inside the evaporation tubes； Intermittent discharge, or regular sewage discharge, is primarily used to remove the sediments that form in water as a result of the addition of chemicals that increase water hardness. Yes, the explanation is clear and straightforward
The last edit to this post was made by design on 2015-9-24 at 13:51. As a supplementary note, a continuous pipe refers to a long tube of roughly tangent length installed inside the boiler, with holes made in it. The position is near the normal water level, so it discharges the water from the surface. Inter-row arrangement typically involves providing an opening at the bottom of the equipment to connect pipes and drain the water from the bottom of the equipment. The functions of the two have been explained very clearly on the 2nd floor.
In series, the valves generally maintain a certain degree of separation； Used to maintain the parameters of the boiler water ； The inter-row spacing is normally closed ； It can be turned on at a set time or upon command, for purpose of adjusting parameters or for large-scale wastewater discharge in case of abnormal conditions
I would like to ask whether your company’s scheduling is done manually or automatically. If it is automated, are pneumatic valves, electric valves, or spring valves used?
The last edit to this post was made by penghh1985 on 2016-3-9 at 17:50. I have two boilers in the factory: one quick-install boiler, where both the exhaust and connection valves are manually controlled; the other is a high-pressure steam drum with only a bottom exhaust valve (controlled by a pneumatic valve)