The liquefied gas pump fails to start due to vacuum conditions
Thread Content
What are good methods for evacuating a liquefied gas pump? It’s relatively difficult to start.
Is the pump inlet pipeline too long and is the liquefied gas pressure insufficient?
Excessive flow at the pump inlet, restricted flow at the outlet
Is the liquefied gas pump evacuated? How to do it? Pump more in
What type of pump? Try opening the outlet valve a little.
I’m not sure about your area, but in our facility, the minimum pressure of liquefied gas entering the storage tank is 8.3 kg/cm3. I have been observing this situation for over a decade; the height of the tank is about 5 meters higher than that of the pump, and the length of the pipelines is around 20 meters. What about flow rate and velocity? Since no problems have occurred, I haven’t delved into those aspects either.
Our liquefied gas pump is a canned motor pump, and it’s not easy to operate even after the recent modification
The presence of non-condensable gases under operating conditions causes cavitation; considerations are needed regarding how to vent these gases, as well as whether there is any blockage in the inlet filter
Import pressure value? What pump?
It can increase the reserve pressure of the liquefied gas tank, thereby significantly reducing the amount of vaporization at the inlet