Differences in the geometric structure of pipe segments during simulation in the pipeline
Thread Content
When simulating in a pipeline, what is the difference between the geometric parameters \"enter segment length and angle\" and \"enter node coordinate\"?
One determines its position based on corners, while the other determines it based on coordinates.
So if you want to set up a 3D pipeline, don’t you have to enter the node coordinates?
The angle is only relative to the vertical projection of the pipe
What does that mean? I still don’t quite understand it
You know everything about three-dimensional coordinates, so why don’t you know about the vertical projection?
You know everything about three-dimensional coordinates, so why don’t you know about the vertical projection?