Can the water flow rate be estimated just by knowing the pressure difference and pipe diameter?
Thread Content
Can the water flow rate be estimated just by knowing the pressure difference and pipe diameter?
Applying Bernoulli’s equation between the pressure points is sufficient
Make a design specification and give it a try
It should be possible; you can see this from the pressure drop formula. There is a definite relationship between pressure drop, flow rate, and pipe fittings, but this relationship may change depending on the flow conditions. The straightforward approach is to assume a certain flow state, calculate the corresponding flow rate, and then check whether it falls within the range for that flow state; you can try this method one by one. I haven’t dealt with these concepts for quite some time since starting work, so I’ve forgotten the specific formulas. You can look up books on fluid mechanics – it’s actually quite easy to understand. I hope this helps you
It’s impossible to estimate; the pressure loss in between cannot be assessed, especially with valves
Yes, it’s similar to the principle used in pitot tubes for measuring speed
hf = det(p)/density, and then use the Fanning formula to calculate the flow velocity. I’m also just learning this; please give some guidance
Yes, reference can be made to Appendix B of the guidelines SH/T 3035-2007 on the selection of pipe diameters for process units in petrochemical enterprises, which deals with flow rate and pressure drop in water pipelines