Measurement of gas phase temperature at the middle section of a packed tower
Thread Content
I would like to ask everyone: how can the gas phase temperature be measured in the middle section of a packed tower? Are components such as liquid collection trays and redistributors necessary? Thank you for the guidance
Aren’t the gas and liquid phases in the filler at the same temperature? Can’t it be simply inserted into the filler?
It’s difficult to insert it directly into the filler, right? Usually, it has to be done in the liquid collection section
After analysis, I think that at a certain point, the temperatures of the gas phase and the liquid phase should be the same, and a thermometer can be inserted directly to measure them. If there are any mistakes, please point them out so that we can all improve together
Since it is about measuring the temperature of the gas phase, there is no need for a liquid collection tray or a redistributor. Simply drill a hole at the location that needs to be monitored and install a heating resistor. However, this temperature should be that of the gas-liquid mixture, as complete separation of gas and liquid cannot be achieved inside the filler.