Help: Why is the assay component not displayed during physical property analysis?
Thread Content
Recently, I used Aspen’s property analysis method to analyze the properties of a certain oil, but problems arose, as follows: Step 1: Run type – select “Property Analysis”; the template to be used is the one for oil refining； Step 2: Determine the ASSAY components (using the D86 curve) ； Step 3: Components input: the defined ASSAY components and water ； Step 4: Physical property analysis input: At this point, a problem arises – only water is displayed, and the ASSAY components I defined are not shown. My ultimate goal is to output the HXDESIGN property type for the ASSAY components I define, as only by doing so can I integrate these properties with those from my other software. I would be extremely grateful if any expert could help solve this.
Assay is not a component; use a virtual component instead.