Regarding the pipeline property table: how should data for the same pipeline but with a changed diameter be entered?
Thread Content
This post was last edited by shiworkstation on 2016-3-14 at 15:11. When changing the diameter of the same pipe, it is generally necessary to start a new line to enter the data. But I’m not sure whether it’s necessary to fill in the values separately according to the pipe diameter in the following situations: 1. When draining completely, the diameter definitely changes ； 2. The inlet and outlet pipes of the pump usually have varying diameters. 3. The branch pipes for control valve assemblies and similar devices generally have varying diameters. 4. The instrumentation requires a diameter change; for example, if a thermometer cannot be inserted into a pipe with a DN40 diameter, the diameter of that section needs to be increased. What are the regulations in everyone’s design institutes? Please give a proper expression. (Extra points)
There are two pipes with different diameters but the same pipe designation, which should be indicated separately. Do not write it if there are only large and small heads but no pipelines