How to treat high-temperature and high-pressure water before discharging it
Thread Content
Hello everyone, I have a question. I want to discharge hot water at 1.0 MPa and 130°C; how can I recover the heat from it before discharging it? What equipment is needed?
Heat exchange, pipes, temperature control system
Could you explain it in more detail? For example, which device reduces voltage
It can be used for heat exchange with materials that need to be heated
It depends on the source of this hot water; does your facility have the medium that requires this heat? Redesign the heat exchanger: tube-and-fin type, shell-and-tube type, or direct mixing
Plate heat exchangers are generally used for heat exchange, and relatively large ones are required; shell-and-tube exchangers yield poor results in this regard. The waste heat can be used to heat the feed material, or a small boiler can be installed to convert it into low-pressure steam through depressurization and vaporization. :Lol, if money isn’t a concern, adding a pressure relief valve to allow direct vaporization and evacuation would work too, right?