Reactor and stirring
Thread Content
When ordering a reaction kettle with a stirrer, if the manufacturer of the reaction kettle and the one who manufactures the stirrer are different, how do these two manufacturers coordinate with each other?
The reactor vessel is the container; the stirring mechanism is integrated with the lid, connected by flanges. Is it possible?
This post was last edited by FORREST_GUMP on 2016-8-1 at 18:35. We are a professional manufacturer of kettles, with specialized companies for mixing services; please contact us via private message if needed
The connection actually boils down to the issue of the connecting flange; simply match the frame with the mechanical seal
The key points for communication between container manufacturers and stirrer design and manufacturing companies are as follows: 1. The stirrer design and manufacturing company shall provide the final drawings to the container manufacturer; it is essential to clarify the specifications of the stirrer’s mounting flanges, the required installation dimensions (with tolerances generally indicated for important dimensions), as well as the design loads (torque, bending moment, vertical load), among other things. 2. The container manufacturer carries out design and finite element analysis based on the parameters related to the mixer; the container drawings must be approved by the owner and the mixer manufacturer before production can begin. Mixers manufacturers pay close attention to verifying whether the specifications and dimensions related to mixer installation, such as the mounting flanges, intermediate bearings or bottom bearings, are in accordance with requirements, as well as whether the manhole sizes and baffles meet the specified standards.
Zibo Tengle Chemical Equipment Co., Ltd. Website: www.sdtlhs.com QQ: 327606198 Phone: 18653370285
Easy to interface: the main issues are related to the flanges at the tank opening, the intermediate supports, or the bottom supports, as well as the alignment dimensions!
It mainly involves the mating of the upper head flange with the frame flange, as well as the mating of the mixer and the reducer; the manufacturer of the mixer is required to provide the dimensions to the tank manufacturer
Just prepare the stirring plan for the reactor