Unit center distance
Thread Content
How to calculate the distance between a turbine and a centrifuge coupling, what are the standards? I would appreciate some guidance
The dimensions are in the equipment installation manual.
What kind of coupling is it? Is the center height reserved?
It is recommended that you consult the manufacturer’s technical department – that will definitely be helpful. Alternatively, you can check the equipment installation records in the equipment files from the time your factory was built to see if there is any relevant information available
I’m the same way; after all, different manufacturers inevitably have differences in certain technologies or aspects of assembly, with improvements and adjustments made
It depends on the amount of expansion of your shaft; the coupling drawings specify the installation dimensions in the cold state
Hehe, it depends on the type of coupling, the diameter of the main shaft, and the axial movement of the shaft. It would be best if the manufacturer provided installation and usage instructions!