Are there any requirements for applying adhesive to the partition surfaces in compressor MCL models?
Thread Content
What are the requirements or standards for applying adhesive to the partition surface in MCL-type compressors? How is compliance determined? Are the partition midplanes and seal midplanes coated with glue?
704 glue will do; gluing is generally not required for the mid-separation surface of the partition or the sealing mid-separation surface, as some partitions have O-ring strips designed for that purpose.
Generally, no glue is needed, unless air leakage is detected at the joint after removing the cover of the large tank and during pressure testing to maintain that pressure. Restricted guarantee for the installation location of the partition. Then ensure that there is no dirt or other contaminants on the mating surfaces of the cylinder block. It is very important that the cross-section of the partition be level with the mating surface of the cylinder block
Mid-surface 704, gasket O-ring, must be heat-resistant.
704 is fine; our company uses 704, and it gives good results.