Does a heat transfer oil furnace require an operation room?
Thread Content
Does a propane-fired heat transfer oil furnace require an operation room? Are there any explicit provisions in the pot regulations or other standards?
No settings are required, but since it is included in boiler management, daily recording and inspection are definitely necessary; if stable operation can be ensured, then they are not needed.
The regulations are indeed unclear; it is recommended to search on Baidu for 【Inspection and maintenance procedures for heat transfer oil furnaces, equipment installation processes, and safety considerations】, which might be useful to you.
Everything is determined by the design; I’ve never seen anything like it, and of course those are all private enterprises.
Generally, there is no need to set up a separate control room; it can be combined with the device control room
Where should a DCS without an operator room be placed? Where does the chief operator work? You can’t be on inspections all the time.
There are plenty of units that don’t have an operator’s room; there’s just a table next to the control panel, and the person sits there.
I’m not sure if it’s necessary; at any rate, I’ve never seen one
Do not lift the pole. Everything is in accordance with the design specifications.