Is such a pipeline technical upgrade appropriate?
Thread Content
The pump outlet pipeline is 1000 mm in diameter; originally, a backwash pipeline with a diameter of 100 was installed on it. Recently, in order to accommodate the catalyst, a pipe with a diameter of 30 was added to the drain connection of the backwash pipeline. On-site observation showed that pipes No. 100 and No. 30 were shaking violently, and their handwheels had become somewhat loose. I was wondering if it’s appropriate to add pipelines in this way? What issues need to be considered? If possible, please explain in detail. I’m a complete beginner in the chemical industry; thank you very much
The design is a mess; isn’t it difficult to arrange it like this? Was it designed by your welders?
May I ask what medium the original poster used?
This post was last edited by Shadowless on 2017-5-30 at 14:53. Installing pipe supports or adding flexible pipe connectors—those two valves practically require telekinesis to operate
……Using scaffolding is mainly to avoid condensation water in summer, thereby facilitating the addition of alkali and catalysts in the absence of desulfurization liquid
Desulfurization lean liquid (components such as catalyst, soda ash, double salts, etc.)
The specialist is getting older, so whatever is most convenient will be used; it’s a pipe connected with a flange under the existing drainage system
I would like to ask what factors and bases need to be considered
I’m not familiar with this, so I can’t comment arbitrarily; it seems that with such thin tubes, there shouldn’t be any major problems!