What method is used for flushing process pipelines
Thread Content
Which of the three methods shown is used for flushing process pipelines? A is the water flushing pipe that enters the process pipeline from bottom to top ； B is the water flushing pipe that enters the process pipeline from top to bottom ； C is the water flushing pipe, which enters the process pipeline from a horizontal direction ； What method is usually used? Could you explain the reason? Thank you!
This post was last edited by qugd on 2019-7-10 at 14:19. It entirely depends on the installation of the process pipelines as well as the operation of the cleaning pipes. The poster needs to first inform them about the piping installation status of the process pipelines on site; where is that diagram? If the process pipeline is horizontal, it is in any case impossible to have the flushing pipe enter the pipeline from above or below for flushing. Those who ask questions without taking into account the specific circumstances are basically idiots.
Hahaha, little steel cannon – you’re everywhere, and you’re always so strong! Impressive.
Hahaha, it’s easy to understand and makes sense
It should be a problem with the flushing water in the material pipeline