Thread Content
What issues should be considered when installing pneumatic miniature control valves? Faults in pneumatic miniature control valves due to improper installation can cause significant losses to enterprises; on the other hand, proper installation ensures the valves operate properly, extends their service life, reduces maintenance efforts, and enables better system control performance. Therefore, the proper installation of pneumatic miniature control valves is a topic of concern for all relevant professionals and companies. A. When installing pneumatic miniature control valves, the following aspects should generally be considered: (1) Control performance: The pressure loss in the piping system should be the same as that taken into account when calculating the size of the control valve, in order to maintain the desired flow characteristics; appropriate straight sections should be maintained at both the inlet and outlet. (2) Installation location: Sufficient space should be available for operators to perform manual operations (including bypass operations), as well as for the easy disassembly and maintenance of the control valve and its accessories. (3) Pneumatic miniature control valve assemblies: In process piping systems, bypass valves together with control valves are usually installed as assemblies, to meet the requirements for continuous operation of the equipment. When servicing or adjusting the control valve, use a shut-off valve to block the flow and a bypass valve for adjustment. B. On-site installation: Installers should first recognize that pneumatic miniature control valves are precision instruments and equipment; they must not be subjected to impacts or drops to avoid damage. The following points should be observed: (1) The valve should be installed vertically and upright on the pipeline. In cases where the valve has a large weight or is subject to vibrations, a support frame should be used. (2) The valve body of the pneumatic miniature control valve should be protected from excessive stress caused by significant misalignment between the pipes upstream and downstream or between the flanges. (3) Before starting up for the first time and after shutdown for maintenance, the piping system should be flushed first before installing the control valve, or a transition filter should be installed in front of the valve. (4) The control valve must be installed in accordance with the direction indicated by the arrow on the valve body