Soda ash automatic packaging line

A packaging line that claims to be able to produce 500 packages per line can only produce over 100 packages in a factory in the west, but the factory in Sichuan can produce 300+ packages. Maybe there are debugging and machine repair personnel here.

There is always a certain gap between design and reality!

At present, the domestic fully automatic lines with relatively stable quality are Habo Shi and Wuxi Lima, but they are only suitable for granular materials. For powdered materials, I advise you to choose semi-automatic!

Could this friend please explain in detail about the powder packaging machine? Thanks!

Nowadays, the more exposed we are to the powder packaging machine, the less we dare to do it. In the past 20 years, we have been exposed to new powder materials. Powder materials are generally divided into the following situations:: 1. Materials with a mesh number below 800 and a specific gravity above 0.5 that do not contain gas.: This type is general-purpose and relatively easy to make. When designing, pay attention to the moisture content of the powder. 2. Gas-containing materials with a mesh number below 800 and a specific gravity above 0.5: The biggest problem with this type of product is how to remove the air that enters the bag during the packaging process. This product was developed after 4 years of testing and was successfully used in the packaging of antioxidants, cryolite, phenolic resin, calcium carbonate, etc. in 2011. 3. The mesh number is between 800 mesh and 5000 mesh, the specific gravity is above 1, and a small amount of gas-containing materials: For materials such as magnesium hydroxide, aluminum hydroxide, and aluminum oxide, the packaging can only operate normally and the accuracy is controlled within a certain range, which is barely good! 4. Nanoscale products with mesh size above 5000: I haven’t done it so far because I don’t dare to do it because I’m not sure it will be done well! 5. Materials with a mesh number below 800 and a specific gravity below 0.5 that do not contain gas.: Depending on the specific material conditions, the design is also more difficult to do well!

Thank you, thank you for your explanation, your explanation is very detailed. study * .

This post was last edited by chen-jun-1024 on 2012-6-12 15:36 The new feeding form, servo feeding, can control the feeding speed and accuracy. This is a good choice!

Can you introduce it in detail? What is the effect if it is a powdery material with a specific gravity less than 1?

This post was last edited by chen-jun-1024 on 2012-6-25 17:22 Servo feeding is the highest level of automatic feeding by automatic metering equipment. The previous feeding form, pneumatic conveying, gravity, etc. is difficult to control the fine links of fine blanking. Servo feeding can fully achieve this purpose. The servo motor can be set to multi-frequency feeding levels, and the speed of coarse, medium, fine and ultra-fine can be adjusted.

If you need new feeding form (servo) dynamic video, please add me QQ434530202