Main fan static blade adjustment
Thread Content
Is the adjustment of the static blades on your main fan done frequently? Can it malfunction if such adjustments are carried out too often?
Has anyone’s stator blades experienced abnormal behavior?
Do not make frequent adjustments; a low air volume can be adjusted by venting through the outlet
Adjustments are not made frequently; our system uses oxygen-enriched combustion, and the main air flow is already sufficient. Slight fluctuations generally do not require any adjustment, and adjustments are only made when there are significant changes in temperature. Frequent adjustments by the stator actuator are definitely not good
We make frequent adjustments here, and no problems have arisen. On the contrary, in the past at Fuyang Recycling, there were few adjustments made, so regular maintenance activities were established to prevent sticking
Our static vanes have also experienced issues such as drifting and sticking, and there have been cases where the check valves became blocked; operation was only possible at the maximum wind pressure, otherwise it would not be safe.
We make frequent adjustments here, and no problems have ever occurred
What kind of craftsmanship do you have? Why make frequent adjustments? Personally, I think it’s best not to make adjustments too frequently, as this affects the system; moreover, fluctuations in airflow volume should be controlled using anti-surge mechanisms.
Is it good to adjust the anti-surge settings frequently? Here, the temperature changes greatly during the day and at night, and the air flow volume also varies significantly; therefore it is necessary to adjust the air flow volume, but not too frequently