Alignment of reciprocating compressors
Thread Content
The readings obtained after replacing the compressor bearing shells are shown in the figure; they fall far short of the required precision of 0.03mm as specified in the drawings. It’s really unbelievable when it comes to Weifang Compressors
Then we really need to look at the manufacturing issues
We also produce compressors in Weifang. Brother, by dealing with these compressors you’ll learn a lot
There seems to be an issue with these radial data and the data in Table 2; the values on the top and bottom as well as on the left and right are not equal – some values are missing.
This situation should occur if measurements are taken right after replacing the bearing shells; it’s necessary to scrape the shells and make repairs
After replacing the bearing shells, it’s necessary to scrape them; check to see what the problem is
The tiles have been laid; the gaps are within the specified limits
The difference is a bit exaggerated~~~~~~~