How to perform on-site dynamic balancing of centrifugal pumps?

Thread Content

How is on-site dynamic balancing performed for centrifugal pumps? We often deal with the issue of on-site dynamic balancing for such pumps. Below, the editor from Lita will give you a brief introduction: When performing dynamic balancing on a water pump, it is necessary to balance the entire rotor assembly. If the impeller is replaced, the balance point changes, and it is necessary to re-adjust it. This is not required for ordinary single-stage pumps, as their residual imbalance has little impact on the pump’s performance. However, for high-speed pumps or multi-stage pumps, dynamic balancing must be performed again. I don’t know much about high-speed pumps; for multi-stage pumps, it is necessary to disassemble the rotor components, perform dynamic balancing, mark the positions of each component, and then assemble the entire pump again in order to achieve dynamic balance. Conditions for dynamic balancing of the water pump rotor: Pumps with high rotational speeds require dynamic balancing, while pumps with lower rotational speeds generally only need static balancing. If a rigid rotor does not meet the conditions of a disc-shaped rotor that can be in static balance, then two planes are required for balancing, that is, dynamic balance. The conditions for rotors that require only static balance are as follows (a balance accuracy of G0.4 grade represents *high precision; in most cases, the dynamic balance accuracy for pump impellers is chosen to be G6.3 or G2.5): 1. For single-stage and two-stage pumps, whenever the operating speed is ≥1800 revolutions per minute, as long as D/b